(6-2), When installing the shower room, first, you can install a wooden
or iron shower base or build a cement platform. For wastewater from the
shower and bath, ensure that the slope of the siphon is at least 3% (0.4
inches per 40 inches) so that the wastewater flows through the natural
gravity to the unit position. If other sanitary units are connected to the
disposal line along the disposal circuit, install check valves in the
appropriate waste pipes to prevent backflow.
Note: Please make sure that the shower room chassis is raised to a
minimum height of 6 inches (15 cm). It also depends on the distance
between the shower room and the pump.
(6-3), If you need to connect more equipment and use the top water inlet,
please open it with a saw and connect it with a hose.
To Next Page
Loading...
