Guard against electric shock
To avoid possible electric shock, do not handle the cutter with wet hands or use the
cutter in rain or damp places. In addition, be aware of all power lines, electric
circuits, and other hazards that may be contacted, especially those below the
surface or otherwise hidden from view.
Unplug tool
Disconnect cutter from outlet when not in use and before cleaning, adjusting or
servicing. Do not disconnect plug from outlet by pulling the cord. Always check that
the switch lock if OFF before plugging in.
Beware of environment
Do not use cutter in the presence of flammable materials (e.g. Paint,
thinner,petroleum products, adhesives).
Do not use cutter in a possibly lighted and clear of obstructions. Operator should at
all times have an unobstructed view of the cutter, rebar and surrounding area.
Wear proper apparel
Do not wear loose clothes, dangling objects or jewellery. Restrain long hair. The
use of a safety-helmet and rubber soled boots is recommended . If safety gloves
are worn, be especially careful that gloves does not get caught in moving parts.
Keep visitors away
Keep all visitors at a safe distance from the work area for their own protection and
to prevent distraction of the operator.
Maintain cutter with care
Inspect cutter before each application. Faulty or loose cutter blocks could result in
personal injury . Keep handle dry, clean and free from oil and/or grease. Keep
housing and piston free of dirt and iron filings. Check that no screws or bolts are
loose or missing. Following instruction for maintenance. Inspect the switch, cord,
plug , and extension cable regularly.
Store carefully
To Next Page
Loading...
