Main shaft 9500 RPM/Min
Z-Axis1200 RPM/Min
Engraving
machine milling
bottom uneven
The spindle is not
perpendicular to the table
Calibrate and level the Z-axis,
or use the engraving machine
spindle to mill the flat plate for
leveling.
Uniaxial or triaxial
movement is
abnormal
The corresponding shaft
connector is loose.
The corresponding motor
wire is loose.
1. Tighten the screws
securing the shaft connector.
2. Reinsert the motor wire
The offset
distance varies
when setting the
origin
1. The limit line is loose.
2. The limit switch failed.
1. Check whether the limit line
is loose.
2. Change the limit switch can
be
1. The engraving speed is
set too fast.
2. Static electricity or
external interference
1. Slow down the carving
speed.
2. Check to see if it is
grounded or if there are any
other high power appliances
running in the circuit
To Next Page
Loading...
