1/14
S3018 CNC Engraving Machine
Catalog
1. Part List…………………………………………………………………...…2
2. Machine Assembly………………....................................................3
3. Control board and Laser………….………..….…...........…..............7
4. Candle Software………………………………………………......…......7
5. Laser Grbl Software……..............................................................11
6. Offline Controller ……………………………………………..……..…13
7. Restore factory settings…….……………….................................14
8. Online guide and video……..……………….................................14
Safty Notice
Avoid direct laser radiation on eyes or skin
Away from children
Always wear protective glasses when use the machine
Prohibited from use in flammable objects or gases
Please cut off the power immediately in case of emergency
Shutdown steps: first cut off the power, then pull out the USB cable
Precautions
(1). All parts description just for illustrative purpose. If there is any difference, please refer to the actual part shape.
(2). Please make sure that the machine is under care when it is working.
(3). If your machine is equipped with an offline controller, please note that the offline controller and the computer
cannot be connected to the engraving machine at the same time, otherwise it will not work normally.
(4). If the U disk in the machine kit can't be read, please scan the QR code to see how to download the software and
related content.
To Next Page
Need help?
General
