9
figure 10 figure 9
5.Push the bowl/tank towards the rear wall of
the unit until it fits snugly around the gasket.
The front fastening hooks must properly engage
(fig.11). Use fresh mix to remove any
remaining sanitizer from the bottom of the
bowls/tanks. Drain this solution and do not
rinse out the machine.
SANITIZING
Prepare a cleaning solution of sodium hypochlorite (1 spoon diluted with 2 liters
of water ).
Sanitize the bowl/tank, gasket and all parts that come in contact with beverage. Rinse
with clear water as recommend.
HELPFUL HINTS
Thickness Adjustment (fig.12)
Figure 12
Proper slush thickness is factory preset.
To change the thickness. (If needed). Use a standard screwdriver turn to the
adjustment screw located at the rear wall of each bowl/tank as follows:-towards the
right(clockwise) to obtain thinner product(the indicator F will go up in opening G)
-towards the left(counter clockwise)to obtain thicker product(the indicator F
To Next Page
Loading...
