Viconics VT8350 - Page 44

028 -0427-15 _UI-V T8350_ A4 _ EN www.viconics.com June 2020
44
VT8350 [ User Interface Guide ]
CONFIGURATION 8/9
PARAMETER DETAILS
Conguration Parameters Default Value Signicance and Adjustments
Calib. temp.
Default value: 0°F (0°C)
Calibration Room Temperature Sensor
Room temperature sensor calibration. Offset can be added or subtracted to
actual displayed room temperature.
Range: ± 5.0°F (± 2.5°C)
Calib. humid.
Default value: 0.0 %RH
Calibrate Humidity Sensor
Offset that can be added or subtracted to actual displayed humidity.
Range: ± 15.0% RH
RH sensor
Default value: Internal
Relative Humidity Sensor
Sets the source of the indoor room humidity. This parameter allows the user to
designate either the Room Controller or any of the paired wireless devices that
support humidity to act as the source for the room humidity.
Internal: Sets the Room Controller as the source for the room humidity.
WL 1 to WL 20: Sets the selected ZigBee wireless device as the source for the
room humidity. Only one device can be selected.
Choices: Internal and WL 1 to WL 20
CO2 source
Default value: Local
CO2 Sensor Source
Sets the source of the indoor CO2. This parameter allows the user to designate
either the optional CO2 detection sensor module (VCM8001) or any of the paired
wireless devices that support CO2 to act as the source for the room CO2.
None: CO2 source disabled.
Local: Sets the optional CO2 detection sensor module as the source for the room
CO2.
WL 1 to WL 20: Sets the selected ZigBee wireless device as the source for the
room CO2. Only one device can be selected.
Choices: None, Local and WL 1 to WL 20
8/9 Conf iguration
Calib. temp.
0.0 °C
RH sensor
Internal
Calib. humid.
0.0 %RH
CO2 source
Local