Victron energy MultiPlus 12/800/35 - TECHNICAL DATA

21
EN NL FR DE ES Appendix
8. TECHNICAL DATA
MultiPlus
12 Volt
24 Volt
48 Volt
12/800/35
24/800/16
48/800/9
PowerControl and PowerAssist
Yes
Transfer switch
16A
INVERTER
Input voltage range
9,5 – 17V 19 – 33V 38– 66V
Output
Output voltage: 230 VAC ± 2%
Frequency: 50Hz ± 0,1% (1)
Cont. output power at 25°C (3)
800VA
Cont. output power at 25°C
700W
Cont. output power at 40°C
650W
Cont. output power at 65°C
400W
Peak power
1600W
Maximum efficiency
92 / 93 / 94%
Zero-load power
7 / 7 / 8W
Zero-load power in search mode
2 / 2 / 3W
CHARGER
AC Input
Input voltage range: 187-265VAC
Input frequency: 45 – 65Hz Power factor: 1
Charge voltage 'absorption'
14,4 / 28,8 / 57,6V
Charge voltage 'float'
13,8 / 27,6 / 55,2V
Storage mode
13,2 / 26,4 /52,8V
Charge current house battery (4)
35 / 16 / 9A
Charge current starter battery
1A (available on 12V and 24V models only)
Battery temperature sensor
Yes
GENERAL
VE.Bus communication port
Remote monitoring and system intergration
Programmable relay (5)
Yes
Protection (2)
a – g
Common Characteristics
Operating temp. range: -40 to +65°C
(fan assisted cooling)
Humidity (non-condensing): max 95%
ENCLOSURE
Common Characteristics
Material & Colour: Steel/ABS (blue RAL 5012)
Protection category: IP21
Battery-connection
25 / 16 / 10 mm²
230V AC-connection
G-ST18i connector
Weight
6,4kg
Dimensions (hxwxd)
375 x 240 x 100mm
STANDARDS
Safety
EN 60335-1, EN 60335-2-29, EN 62109-1
Emission / Immunity
EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3
Road vehicles
EN 50498
1) Can be adjusted to 60Hz and to 240V
2) Protection
a. Output short circuit
b. Overload
c. Battery voltage too high
d. Battery voltage too low
e. Temperature too high
f. 230VAC on inverter output
g. Input voltage ripple too high
3) Non-linear load, crest factor 3:1
4) At 25°C ambient
5) Programmable relay which can be set for general alarm,
DC undervoltage or genset start signal function
AC rating: 230V/4A
DC rating: 4A up to 35VDC, 1A up to 60VDC