Victron energy Quattro 48/15000/200 User Manual

2020-11-12 10:43 1/11 Victron Energy and Discover AES Batteries
Victron Energy - https://www.victronenergy.com/live/
Victron Energy and Discover AES Batteries
The Discover AES range of Lithium Iron Phosphate batteries is compatible with Victron products in
various systems.
These instructions are intended to be used in conjunction with the product manual(s) supplied by
Discover Battery.
These instructions are current as of 2019-07-23. More recent updates to Victron device firmware or
Discover Battery, LYNK or Edge Card device firmware may alter set up instructions.
For the latest product details, installation and operation manuals, visit the Discover Battery website
https://discoverbattery.com » Solutions » Solar » Resources or use this direct link
https://solar.discoverbattery.com/aes-lifepo4-batteries-renewable-energy/
1. Introduction
The Discover AES LiFePO4 Battery includes a Battery Management System (BMS) within each battery
pack. The BMS interfaces with the Victron GX device and can support multiple batteries connected in
parallel.
These instructions provide information about the integration of Discover AES Lithium batteries with
Victron Energy devices in a Closed Loop configuration using the AES LYNK Communication Gateway
with installed AES LYNK Edge Card for Victron. AES batteries can be use in an Energy Storage System
(ESS) for self consumption, Grid backup and Off-grid applications. These instructions apply to an off-
grid application.
NOTE: In a Victron networked system the charging variables will be managed automatically by the

Victron energy Quattro 48/15000/200 Specifications

General

Model	Quattro 48/15000/200
DC Input Voltage	48 V
AC Output Power	15000 VA
Output Voltage	230 V AC
Output Current	65 A
Charge Current	200 A
Protection	Overload, short circuit, over temperature, reverse polarity
Operating Temperature Range	-40 to +65 °C

Summary

Introduction to Victron Energy and Discover AES Batteries

Documentation for Victron and Discover AES Batteries

System Overview and Battery Capacity

System Overview

Explains the LYNK Communication Gateway's role in optimizing battery performance in closed-loop systems.

Minimum Battery Capacity

Outlines how to size battery capacity based on inverter/charger and load surge requirements.

Configuring Victron Products for AES Batteries

Powering Up Victron Equipment

Steps for safely connecting and powering up Victron devices and AES batteries.

VE.Configure Settings for Off-Grid

Specific Victron VE.Configure parameters for off-grid AES battery integration.

VE.Direct MPPT Settings

Precautionary settings for Victron MPPT charge controllers used with AES batteries.

Installing and Connecting LYNK to Victron Network

Installing the LYNK Edge Card

Details on physically installing the LYNK Edge Card into the Communication Gateway.

Connecting LYNK to the Victron Network

Steps to establish communication between the LYNK Gateway and Victron GX devices.

System Set Up and Synchronization

Synchronizing Victron System with AES Battery

Guides on setting up the CAN-bus profile for AES battery communication within the Victron system.