TYPICAL FAILURE POSSIBLE CAUSE REPAIR
Wash
Rinse
No agitation or
poor agitation
Power plug is not connected properly Insert power plug correctly
Defective Motor
Defective Timer
Defective Gear-Box
Replace
Clothes or objects bit in pulsator gap Remove pulsator and check.
Remove objects
Defective mounting of pulsator screw Fixing pulsator
Belt loose Adjust the belt tention
Too large amout of wash load Take out some clothes
Excessive
noise during
agitation
Coin or button between pulsator andtub Remove objects
Defective Bearing Case Replace Bearing Case
Defective fixing of pulley or transformed Adjust pulley or replace it
Drain No Drain
Drainning does
not stop
Drain Hose is not lowered
Make sure to lower drain
hose
Lints accumulated in Drain Hose Clean or replace Hose
Cock Rod A is broken or seperated Replace or connet
Defective DV Bellow Adjust or replace
D.V-Spring is broken away or elesticity is
insufficient
Adjust or replace D.V-spring
Guide-A.T is derailed or defective Guide-A.T
Adjust or replace
Spin No spinning Lid is open Close the lid adn advise
customer
Out of adjustment of Safety Switch or
defective Safety Switch.
Adjust fixing positon of
Safety Switch or replace
Safety Switch
Defective Spin imer Replace
Brake wire is broken.
Replace B r a k e w i r e
6. SERVICE INFORMATION
6-3. TROUBLE SHOOTING
20
To Next Page
Loading...
