Viega Smartpress - 3.3.5 Leakage Test; 3.4 Maintenance

3.3.5 Leakage test
NOTICE!
Also refer to the information for use on leakage detection
agents, see Ä Chapter 2.4.1 „Chemical resistance“
on page 15.
The installer must perform a leakage test before commissioning.
This test is carried out on a system that is finished but not yet covered.
Observe the applicable regulations, see Ä „Regulations from section:
Leakage test“ on page 7.
Leakage test should also be carried out for non-potable water installa‐
tions in accordance with the applicable regulations, see
Ä „Regulations
from section: Leakage test“ on page 7.
Document the result.
3.4
Maintenance
Observe the applicable regulations for the operation and maintenance
of drinking water installations, see Ä „Regulations from section: Mainte‐
nance“ on page 7.
3.5
Disposal
Separate the product and packaging materials (e. g. paper, metal,
plastic or non-ferrous metals) and dispose of in accordance with valid
national legal requirements.
Handling
Viega Smartpress 23 from 23