VITODENS 100-W / 111-W
Heating circuit 1 and 2
DHW temperature
System pressure
DHW ECO function
Reduced temperature level
Wifi connection
Service menu
Fault display
Burner status
OK > confirm settings
Menu > opens the main menu
Up & down > change parameter
Getting started
On the following pages you will find a step by step guide to commission the product by using
the control panel. The default parameters are highlighted for each step. Note that you can also
use ViGuide – our mobile application – to carry out the commissioning. Important: If you want to
connect the boiler to the internet – using ViGuide monitoring – or connect a Viessmann ViCare
Thermostat or Vitotrol 100-E you have to use ViGuide. Please refer to the last page of this docu-
ment to receive more information.
User interface
OK
Commissioning Quickstart Guide
This guide highlights the new and unique process for commissioning. For installation,
please refer to the detailed steps in the Installation & Service Instructions.
To Next Page
Need help?
General
