Viessmann VITOCELL 100-V - DHW Cylinder (300 Litres)

12
Fitting the cylinder temperature sensor and thermometer sensor (if supplied)
8.
2.
6.
5.
3.
4.
1.
7.
8.
Fig. 9
■
Sensor retainer is supplied with the fascia.
■
Secure the sensor on the outside of the sensor
retainer contact spring (not in the groove) so that it is
flush with the front of the spring.
■
Never wrap insulating tape around the sensor.
■
Insert the sensor retainer with sensor into the sensor
well as far as it will go.
■
Insert the thermometer sensor as far as it will go into
the clamping bracket on the flange cover.
Installation sequence
DHW cylinder, 300 l
6150608
Installation