6. Confirm the set value with d.
Note
The control unit changes automati-
cally to burner stage 2. The display
shows "Speed stage 1 + 2 " and a
value between 1 and 255.
7. Repeat steps 4 and 5 for burner
stage 2.
8. Check the set values.
9. Seal test connector A again with
the previously removed plug.
Note
Do not seal the connector next to
test connector A.
Further details regarding the individual steps (cont.)
15
Initial start-up, inspection, maintenance
5692 536 GB
To Next Page
Loading...
