Note
Part no. for pH test strips: 9517 678.
Observe the manufacturer's instructions regarding the neutralising system.
Checking the active charcoal filter (accessories)
Note
Observe the manufacturer's instructions regarding the active charcoal filter.
Matching the control unit to the heating system
Note
Subject to the equipment level, the control unit must be matched to the system.
Various system components are recognised automatically by the control unit
and the relevant codes are adjusted automatically.
&
For the selection of an appropriate design, see the following diagrams.
&
For coding steps, see page 38.
System design 1
With/without DHW heating with one heating circuit without mixer A1
! Outside temperature sensor % Cylinder temperature sensor
Further details regarding the individual steps (cont.)
24
Initial start-up, inspection, maintenance
5692 536 GB
To Next Page
Loading...
