11
The remote control allows you to make the following
settings from your living space:
■
Room temperatures
■
DHW temperature
■
Holiday program and "Holidays at home"
■
Time phases for central heating
■
Time phases for DHW heating
■
Once-only DHW heating
■
Language
All settings are transferred from the remote control to
the control unit and vice versa. It is always the most
recent settings that apply.
14°C 20,5°C
17:35Sa 14.07.2018
HK1
OK
?
Fig. 1
To take one step back in the menu.
Or
To terminate an adjustment in progress.
Cursor keys
Scrolls through the menu or adjusts values.
OK Confirms your selection or saves the setting
made.
Calls up "Operating info" (see following chapter)
or additional information on the selected menu.
Calls up the menu.
2 control levels are available:
■
The standard menu: See page 12.
■
The extended menu: See page 13.
Note
If you have not adjusted any settings on the remote
control for a few minutes, the display illumination is
reduced or switched off (screensaver).
This function can be changed: See page 23.
Symbols on the display
These symbols are not always displayed, but appear
subject to the system version and the operating state.
Displays:
Frost protection is active.
Central heating with reduced room temperature
Central heating to standard room temperature
Central heating to comfort room temperature
Comfort mode is active.
Burner is operational.
Current time
One-off cylinder heating is active.
Heating circuits:
HC ... Heating circuit ...
Operating program displays:
Standby mode is active on the heat generator
control unit.
DHW heating is active on the heat generator con-
trol unit.
Indoor environment (central heating) is active on
the heat generator control unit.
Holiday program is active.
"Holidays at home" is active.
Messages:
Fault
Service
Calling up general "Operating info"
The display shows brief instructions on how to operate
the device.
Operating the remote control
Operating the remote control
5839324
To Next Page
Loading...
