ViewSonic CDE4320 - Initial Operation and Setup; Setup Wizard and Network Configuration

11
4. Operation
NOTE
: The control button described in this section is
mainly on the remote control unless specied
otherwise.
4.1. Start-up and initial Setting
4.1.1. Welcome
Select your language and tap “Next”.
4.1.2. Ethernet
Tape “Next” button to next page and it will show.
1. Connection Type : DHCP / Static IP
2. IP Address
3. Netmask
4. DNS Address
5. Gateway
You also can tape “Back” to previous page.
4.1.3. Date & Time
Enable “Network-provided time” to sync time
with network and select time zone.
4.2. Watch the Connected Video Source
1. Press
INPUT
button.
2. Press or button to select a device, then
press OK button.