ViewSonic LS810 - Presentation Timer and Screen Control

34
Setting the Presentation Timer
The presentation timer can indicate the presentation time on-screen to help you achieve
better time management when giving presentations. Follow these steps to utilize this
function:
1. Use the remote control
and enter Presentation Timer menu or enter Basic>
Presentation Timer menu.
2. Press [Enter] to show the Presentation Timer page.
3. Select Timer Period and press / to conrm the duration. Duration can be set to 1
to 5 minutes, with 1 minute increments, or 5 to 240 minutes in 5 minute increments.
Oncethetimerhasbeenactivated,resettingthetimerintervalwillre-activatethetimer.
4. Press  and select the Timer Display. Then press / to select whether to display
or hide the on-screen timer.
Selection Description
Always Displays the timer on screen throughout the presentation time.
1 min/2 min/3 min Display timer on-screen in the last 1 / 2 / 3 minutes.
Never Hides the timer throughout the presentation time.
5. Press  and select Timer Position, and then press / to set timer location.
Top- Left BottomLeft Top Right BottomRight
6. Press  to select Timer Counting Direction, then press / to select the required
timer method.
Selection Description
Count Up Increases from 0 to the preset time.
Count Down Decrease from the preset time to 0.
7. To activate Presentation Timer, press , then press / and select Start Counting,
then press [Enter].
8. A conrmation message will be displayed next. Select Yes and press [Enter] to
conrm the selection. The screen will display the message [Timer is On!]. Once
activated, the timer will start its countdown.
Tocancelthetimer,performthefollowingsteps:
1. Enter Basic>PresentationTimer menu.
2. Select OFF. Press [Enter]. A conrmation message will be displayed afterwards.
3. Select Yes and press [Enter] to conrm the selection. The screen will display the
message [Timer is Off!].