11
Key safety instructions
Design and testing of your projector have been carried out in compliance with the
latest safety standards for information technology (IT) devices. However, it is extremely
important for you to follow the instructions provided in this manual and product labels
during use to ensure user safety.
Safety Instructions
•Please read through this manual before using the projector. Save it for future
reference.
•Do not look directly into the projector lens during use. The intense light beam
may damage your eyes.
•Referservicingtoqualiedservicepersonnel.
•Always open the lens shutter or remove the lens cap when the projector light
source has been switched on.
• Stable line voltage may not be available in certain countries. This projector is designed
to operate safely within a mains voltage between 100 to 240 volts AC, but could fail
if power cuts or surges of ±10 volts occur. In areas where the mains voltage may
uctuateorcutout,itisrecommendedthatyouconnectyourprojectorthrough
apowerstabilizer,surgeprotectororuninterruptiblepowersupply(UPS).
• Do not block the projection lens with any object when using the projector as this could
cause the said objects to overheat, deform, or even cause a re. To temporarily turn
off the light source, press the [BLANK] button on the projector or remote control.
• Do not place the projector on an unstable cart, stand, or table. The product may fall
and sustain serious damages.
• Do not attempt to disassemble this projector. The projector contains high voltage parts
that may cause electrocution or death when it comes in contact with the human body.
Under no circumstances should you ever undo or remove any other covers. Refer
servicing to qualied service personnel.
• Do not place the projector in any of the following environments.
- Space that is poorly ventilated or conned. Allow at least 50 cm clearance from
walls and ensure free ow of air around the projector.
- Locations where temperatures may become excessively high, such as the inside of
a car with all windows rolled up.
- Locations that are too humid, dusty, or smoky may contaminate optical
components, shortening the projector's life span and darkening the image.
- Locations near re alarms
- Locations where temperature exceed 35°C/104°F.
- Locations with altitudes greater than 3000 m (10000 feet).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
