ViewSonic M1 Pro - Making Connections; Powering and Battery Usage

15
Making Connecons
Connecng to Power
DC Power (Power Outlet)
1. Connect the power cord to the power adapter.
2. Connect the power adapter to the DC IN jack at the side of the projector.
3. Connect the power cord plug to a power outlet. When connected, the status LED
will turn red.
1
2
3
NOTE: Charge the projector for 2 hours via the power adapter before using it in
baery mode for the rst me.
IMPORTANT
 Use only the bundled power adapter to change the baery pack and supply
power to your LED projector.
 Ensure that your LED projector is connected to the power adapter before
turning it on for the rst me. We strongly recommend that you use a
grounded wall socket while using your LED projector in power adapter
mode.
 The socket outlet must be easily accessible and near your LED projector.
 To disconnect your LED projector from its main power supply, unplug your
LED projector from the power socket.