ViewSonic P220f User Manual

FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
To assure continued FCC compliance, the user must use grounded power supply cord and the provided
shielded video interface cable with bonded ferrite cores. If a BNC cable is going to be used, use only a
shielded BNC(5) cable. Also, any unauthorized changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this device.
Notice for Germany
The x-rays generated in this unit are shielded sufficiently. High voltage: Max. 30 kV. Also, for ergonomic
reasons, we recommend that you do not display blue characters on a dark background. Doing so may
produce insufficient contrast that could lead to eye strain.
Notice for Japan
This is a Class B product based on the standard of the Voluntary Control Council for Interference from
Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic
environment, it may cause radio interference. Install and use the equipment according to the instruction
manual.
CE Conformity
The device complies with the requirements of the EEC directive 89/336/EEC as amended
by 92/31/EEC and 93/68/EEC Art.5 with regard to “Electromagnetic compatibility,” and 73/
23/EEC as amended by 93/68/EEC Art.13 with regard to “Safety.”
ViewSonic P220f 18

ViewSonic P220f Specifications

General

Type	22\
Pixel pitch	0.24 mm
Display diagonal	22 \
Vertical scan range	50 - 160 Hz
Horizontal scan range	30 - 110 kHz
Viewable size, vertical	300 mm
Viewable size, horizontal	400 mm
Audio system	No
Video in	Bandwidth - 266MHz (typical)
I/O ports	Signal - High-density 15 pin mini D-sub Power - 3-pin plug (IEC 320)
Mounting interface	Plug & Play
Maximum resolution	2048 x 1536 pixels
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Certification	TCO'03, TÜV/GS, TÜV/ERGO, ISO9241-3, ISO9241-7, ISO9241-8, Energy 2000, MPR-II, CE, CB, FCC-B, UL, CSA, DHHS, DOC-B, NEMKO, DEMKO, SEMKO, FIMKO, B-Mark, PCT, SASO, CCIB, C-Tick, S-Mark, NOM, VCCI, IRAM, ICE5003, CCEE, EMC, EMI-B
Power source	AC 100-240V, 50/60 Hz (auto switch)
Power management	Energy Star, VESA DPMS, TCO'03 Energy 2000
Power consumption (typical)	125 W
Mac compatibility	Yes
Compatible products	PC compatible from VGA up to 2048 x 1536. Power Mac compatible from 640 x 480 to 2048 x 1536. Other - Most workstations

Weight and Dimensions

Weight	31000 g
Dimensions (WxDxH)	500 x 511.5 x 505 mm