ViewSonic PJ1065 - Basic Operation; Input Signal Selection

10 ViewSonic PJ1065
Basic Operation
The basic operations shown in Table 3 can be performed with the supplied remote control device or
by way of the projector’s control panel. Items indicated by (*) may be used from the control panel.
Table 3: Basic Operation
NOTE:
• Use the remote control device at a distance of approximately 5 m from the sensor on the
front of the projector, and within a range of 30 °left-right. Strong light and obstacles will interfere
with the operation of the remote control device.
Item Description
INPUT
SELECT
Select Input Signal
(*)
:
Press the INPUT button.
RGB IN 1
→
RGB IN 2
→
DVI
→
VIDEO
→
S-VIDEO
→
COMPONENT VIDEO (
→
RGB IN 1)
Select RGB Input:
Press the RGB button.
VIDEO/S-VIDEO/COMPONENT VIDEO
→
RGB IN 1/RGB IN 2/DVI
RGB IN 1
→
RGB IN 2
→
DVI (
→
RGB IN 1)
Select Video Input:
Press the VIDEO button.
RGB IN 1/RGB IN 2/DVI
→
VIDEO/S-VIDEO/COMPONENT VIDEO
VIDEO
→
S-VIDEO
→
COMPONENT VIDEO (
→
VIDEO)
• The selected signal name is displayed for approximately 3 seconds when the
input signal is changed.
POSITION
Set/Clear Position Adjustment Mode:
Press the POSITION button.
The [ ] icon is displayed in the POSITION mode.
Image Position Adjustment:
Press the and buttons in the
POSITION mode.
• Valid only in the MAGNIFY mode if a video signal is input.
• After approximately 10 seconds of inactivity the [ ] icon is extinguished and the
POSITION mode will be cleared automatically.
• and buttons may operate as the mouse control button. See page 4.
RESET (*)
Initialize Each Item:
Select an item and press the RESET button.
Initialize Position Adjustment:
Press the RESET button and the
POSITION mode. This function is valid only if a RGB signal is the input.
• Valid except for the VOLUME, LANGUAGE, WHISPER and H PHASE.
• The RESET button may operate as the mouse control button. Refer to page 4.
MAGNIFY
Set MAGNIFY Mode:
Press the MAGNIFY button.
Move Magnified Area:
Run the POSITION in the MAGNIFY mode.
Adjust Magnification:
Press the MAGNIFY button in MAGNIFY mode.
Clear MAGNIFY Mode:
Press the MAGNIFY button.
•
The MAGNIFY mode is cleared by running or setting the AUTO, ASPECT, INPUT
SELECT or VIDEO, or by changing the input signal.
FREEZE
Set/Clear FREEZE Mode:
Press the FREEZE button. The [ ] icon is displayed,
and the image will be frozen in the FREEZE mode.
• The FREEZE mode is cleared by running or setting POSITION, VOLUME, MUTE,
Automatic Adjustment, BLANK ON/OFF, or MENU ON/OFF, or by changing the
input signal.
• Do not forget to clear frozen static images.