11ViewSonic PJ406D
Powering On the Projector
1.
Remove the lens cap.
2.
Ensure that the power cord and signal cable are securely
connected. The Power LED will turn Orange.
3.
Turn on the lamp by pressing “Power/Standby” button on
the control panel.
The startup screen will display for 10 seconds and the Power
LED will turn green.
4.
Turn on your source (computer, notebook, video player,
etc.). The projector will detect your source automatically.
If you connect multiple sources at the same time, use the
“Source” button on the control panel or remote control to
switch.
Powering On/Off the Projector
Turn on the projector
fi rst and then the signal
sources.
1
Power/Standby
2
Lens Cap
To Next Page
Loading...
Need help?
General
