ViewSonic PJ406D User Manual

12ViewSonic PJ406D
Warning Indicator

When the “TEMP” indicator turns red, it indicates the projector
has overheated. The projector will automatically shut itself down.

When the “LAMP” indicator turns
red
, it indicates a problem
with the lamp. Turn off the projector and disconnect the power
cord from the electrical outlet, then contact your local dealer or our
service center.

When the “LAMP” indicator fl ashes
red
(1 second intervals)
, it
indicates the fan failed. Stop using the projector and disconnect
the power cord from the electrical outlet, then contact your local
dealer or our service center.
Powering Off the Projector
1.
Press the “Power/Standby” button to turn off the projec-
tor lamp, you will see a message as below on the on-screen
display.
2.
Press the “Power/Standby” button again to confi rm.
3.
The cooling fans continue to operate for about 30 seconds for
cooling cycle and the Power LED will fl ash orange. When
the light stops fl ashing, the projector has entered standby
mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press
“Power/Standby” button to restart the projector.
4.
Disconnect the power cord from the electrical outlet and the
projector.
5.
Do not turn on the projector immediately following a power
off procedure.

ViewSonic PJ406D Specifications

General

Brand	ViewSonic
Model	PJ406D
Category	Projector
Language	English