ENGLISH
SNMP setting
This projector provides a SNMP (Simple Network Management Protocol)
agent function. The SNMP consists of a manager and agents. The group
which communicates information each other with SNMP is called
"Community". There are two access modes in a community, Refer (read only) and Set (read-
write). This projector allows to use Refer (read only) only. The SNMP message informs the pro-
jector status called "Trap" to an administrator. Click
SNMP Setting
on the main menu and
set up each item.
Item Description
Contact...............................................Enter user name of the projector etc. (optional)
Place .....................................................Enter place of the projector (optional)
Community name(refer).......Enter community name (read only). Default name is "public".
PJ information
SNMP setting
Item Description
Community name......................Enter community name to send "Trap". Default name is "public".
Trap address...................................Enter IP address of the SNMP manager computer to receive "Trap".
Trap
Downloaded From projector-manual.com Viewsonic Manuals
To Next Page
Loading...
