ViewSonic PJL6233 - Page 82


Appendix
Status Read Command
Format
The command is sent from PC to the projector with
the format below;
‘CR’ [Command] ‘CR’
Command: one character (refer to the command
table below.
The projector decodes the command and returns the
‘Character string’ with the format below;
7KHWDEOHVRQSDJHVDQGVKRZWKHW\SLFDOFRPPDQGOLVWVIRUFRQWUROOLQJWKHSURMHFWRU3OHDVHFRQVXOW\RXU
local dealer for further information of other commands.
Command Function Projector Return Projector status
&5 Status Read

Power On

6WDQGE\PRGH

Countdown

Cooling down

Power Malfunction

Cooling down at the temperature anomaly

6WDQGE\PRGHDIWHU&RROLQJGRZQDWWKHWHPSHUDWXUH
anomaly.

Cooling down at Power Management mode

Power Management mode after Cooling down
21
Cooling down after the projector is turned off when
the lamps are out.

6WDQGE\PRGHDIWHU&RROLQJGRZQZKHQWKHODPSV
are out.
&5
Temperature
Read

 7HPSHUDWXUHDW6HQVRUÛ&
 7HPSHUDWXUHDW6HQVRUÛ&
 7HPSHUDWXUHDW6HQVRUÛ&
H[ Û& Û& Û&
!7KHSURMHFWRUGLVSOD\V³´
( For each sensor, two digit and the tenth place
numbers are displayed with a space between each
temperature.)
?
Communication failure
Downloaded From projector-manual.com Viewsonic Manuals