15
Powering On the Projector
1. Remove the lens cap.
2. Securely connect the power cord and signal cable. When connected, the Power
LED will ash blue.
3. Turn on the projector by pressing “
” button on the control panel. The Power
LED will turn blue.
4. Turn on your source that you want to display on the screen (computer, note-
book, video player, etc). The projector will detect the source automatically and
will display on the screen.
5. If you connected multiple sources at the same time, press the “Source” button to
switch between inputs.
Powering On/Off the Projector
2
1
To Next Page
Loading...
