46
Command Table
Herder code Command Function Description
# @ & @ 2 3 2 0 0 1 Power on Turn on projector
0 0 2 Power off Turn off projector
0 0 3
Keystone
Menu
Enter keystone adjustment feature
0 0 4 Mute Turn on/off mute function
0 0 5 Freeze Display freeze
0 0 6 Menu Enter to main menu
0 0 7 Up Up direction operating
0 0 8 Down Down direction operating
0 0 9 Right Right direction operating
0 1 0 Left Left direction operating
0 1 1
Factory
Reset
Execute reset to factory default
0 1 2 Re-sync Re-sync input source timing
0 1 3 Enter Enter to selected item
0 1 4 Exit Exit OSD
0 1 5 VGA Switch to VGA source
0 1 6 S-Video Switch to S-Video source
0 1 7 Video Switch to Video source
0 1 8 HDMI2 Switch to HDMI2 source
0 1 9 16:9 Switch to aspect ratio 16:9
0 2 0 4:3 Switch to aspect ratio 4:3
0 2 1 Anamorphic
Switch to aspect ratio Anamorphic
mode
0 2 2 Wide Switch to aspect ratio Wide mode
0 2 3 Vol+ Volume up
0 2 4 Vol- Volume down
0 2 5 Brightness Brightness adjustment
0 2 6 Contrast Contrast adjustment
0 2 7 ColorTemp Color Temp adjustment
0 2 8 Hide Hide status message
0 2 9 Source Switch to next input source
0 3 0 Saturation Saturation adjustment
0 3 1 Tint Tint adjustment
To Next Page
Loading...
