ViewSonic VS16500 - Replacing the Remote Control Battery

11
Replacing the remote control battery
1. To open the battery cover, place the remote control with the backside facing upwards.
Press down at the indicated area and then pull the battery lid upwards along the indi-
cated direction.
2. Take out the old batteries (if required) and then place 2 AAA batteries according to
the indicated orientation. The positive pole of the battery should be directed at the (+)
direction while the negative pole should be directed at the direction.
3. Align the battery lid with the bottom part of the remote control and push downwards.
Return the lid to its original position to complete the process.
Warning
• Avoidplacingtheremotecontrolandbatteryinhotandhumidenvironmentssuchaskitchens,bathrooms,
saunas,tanningrooms,orwithinvehicles.
• Replace batteries only with the same or equivalent type of batteries recommended by the battery
manufacturer.
• Refer to the manufacturer’s instructions and local environmental regulations to dispose of old batteries.
• Donotthrowbatteriesintores.Theremaybedangerofanexplosion.
• Ifthebatteryisatorifyouwillnotbeusingtheremotecontrolforawhile,removethebatterytoprevent
battery leaks from damaging the remote control.