26
Correcting keystone
Keystone distortion is a problem where the projected image becomes trapezoidal in shape
(keystone distortion) as a result of poor projection angle.
To correct this situation, you should adjust projector height and use the following steps to
correct the issue manually.
• Using the remote control
1. Press
/ / / to display the Keystone Correction page.
2. Press
to initiate Keystone Correction at the
top of the image. Press to initiate Keystone
Correction at the bottom of the image. Press
to initiate Keystone Correction at the right
side of the image. Press to initiate Keystone
Correction at the left side of the image.
Press Press
• Using the OSD menu
1. Open the OSD menu and open Display >
Keystone menu.
Press Press
2. Press the button to initiate Keystone Correction at the top of the image or press
the button to initiate Keystone Correction at the bottom of the image.
3. Open the OSD menu and open Display > Keystone menu.
4. Press [Enter]. This will bring up the Keystone page.
5. Select Vertical and then press
to initiate Keystone Correction at the top of the
image or press to initiate Keystone Correction at the bottom of the image.
6. You can also select Horizontal and then press
to initiate Keystone Correction at
the right side of the image. Press to initiate Keystone Correction at the left side of
the image.
To Next Page
Loading...
