ViewSonic VS17612 - Mounting the Projector

1818

 If you buy a third party mount, please use the correct screw size. Screw
size can vary depending on the thickness of the mounng plate.
1. To ensure the most secure installaon, please use a ViewSonic® wall or ceiling
mount.
2. Ensure the screws used to aach the mount to the projector meet the following
specicaons:
• Screw type: M4 x 8
• Maximum Screw Length: 8 mm

• Avoid installing the projector near a heat source.
• Keep at least a 10 cm (3.9 in.) gap between the ceiling and the boom of
the projector.