ViewSonic VS18325 - Network

7777
NetWork
1. Press MENU on the remote control to display the OSD Menu.
2. Then press OK or use q/p/t/u on the remote control to select the NetWork
menu.
3. Press q/p to select the menu opon. Then press OK to display its sub-menu, or
press t/u to adjust/select the seng.
NOTE: Some sub-menu opons may have another sub-menu layer.
Menu Opon Descripon
Ethernet Seng
Ethernet Switch
Toggle the wired network connecon On or O.
Connecon Mode
Select the network connecon method, DHCP IP or Stac IP.
NOTE: If Manual IP is selected, you need to congure the IP,
Netmask, Gateway, and DNS.
Network Status
View the network connecon status.