Viken Detection Pb200i - Turning the GPS Receiver On;Off

Page 28
Turning On the GPS Receiver
The Pb200i is equipped with an onboard GPS receiver, which is set to “On” by default at the factory.
Follow these steps to turn on/off the GPS receiver. Select the “Settings” icon (Fig. 81).
Scroll down to “Location Access” (Fig. 82) and select. Slide “Access to my location” to “ON” (Fig. 83). The
icon in shown in Figure 84 will appear when GPS is enabled.
Figure 81
Figure 82
Figure 83
Figure 84