Viken Detection Pb200i - Changing the Action Level; Adjusting Action Level Mode Settings

Page 35
Turn the “Delete Data” toggle to the “OFF” position and back out with the Back button (Fig. 123 to 125).
In the example shown here, when the user logs in, if they try to delete data, they will see the error
message shown (Fig. 126). If they went to their settings, the choice to “Delete Data” is no longer available
(Fig. 127).
Changing the Action Level in Action Level Mode
In some instances, the user will want to change the action level to accommodate a Pb threshold other
than the default of 1.0 mg/cm
2
. In order to change the action level, start at the main menu, select
Setup>Mode>Action Level Mode, tap the gear icon and input the number (Fig. 128 to 133). Press the
Back button (Fig. 134).
Figure 123
Figure 124
Figure 125
Figure 126
Figure 127
Figure 128
Figure 129
Figure 130
Figure 131