Viken Detection Pb200i - Using Wi-Fi for Data Transfer; Enabling Wi-Fi and Network Connection

Page 23
Using Wi-Fi Connectivity
You can also use Wi-Fi to transfer your data via an FTP client. To enable Wi-Fi usage, select the
“Settings” icon (Fig. 67). Enable Wi-Fi by swiping right; the “Wi-Fi” icon will appear (Fig. 68).
After enabling Wi-Fi, tap on the word “Wi-Fi” as circled in Fig. 68. Find the desired network, select and
connect (Fig. 69). Enter any required Wi-Fi password to proceed.
Exit from Wi-Fi using the left arrow, then close the “settings” app by holding the center “Home” button
down until a list of open apps appears (Figure 70). Swipe left to close the Settings app.
Caution: Turning on Wi-Fi will decrease the battery life of the Pb200i. We recommend leaving
the Wi-Fi feature off when it is not in use.
Figure 67
Figure 68
Figure 69
Figure 70