Viken Detection Pb200i - Creating an Administrator Account; Initial Login and First User Setup

Page 29
To check the status of your GPS, go to the following screens Setup>Hardware>GPS (Fig. 85-88).
Creating an Administrator
When first logging on to the Pb200i, you will need to create a username and password. Start by using the
factory default password: 371945.
You will be prompted to create the first user. This person will be the device administrator, and can
administer rights to other users as needed. This person should be a high-level employee, responsible for
the instrument, such as the radiation safety officer (RSO).
Login using the default password. When prompted to “create user?” select yes. Enter the text for your
new password. Contnue by loging in using the new password. (Fig. 89 to 91).
Caution: User names must be a minimum of four characters. Passwords must be a minimum of six
characters.
Figure 85
Figure 86
Figure 87
Figure 88
371945
Figure 89
Figure 90
New name and
password
Figure 91