To create a user ID on the Pb200i, start at the main menu. Select Setup>Users>Create User. Select
“User” and create a new password.
Caution: Only an administrator can set up these rights (Figures 108 to 112).
Modifying Permissions
An administrator can modify the permissions for themselves, a Supervisor, or a User. A Supervisor can
only modify the permissions for a User.
The example shown here illustrates the administrator revoking the default permission to delete data for a
user’s ID.
Start at the main menu. Select Setup> Users>Modify>Permissions. (Fig. 113 to 116) Select the user and
change “Allow” to “Disallow” (Fig. 117 to 119). The factory default settings are shown in Figure 118.
To Next Page
Loading...