Need help?Do you have a question about the Viking Access Systems X-390 and is the answer not in the manual?
General warnings for safe operation and installation of gate operators.
Key requirements for safe and compliant gate operator installation.
Procedures for keeping the gate operator in good working order.
Essential safety precautions for installation, use, and maintenance.
Defines gate operator classes for residential, commercial, industrial, and restricted access.
Mandates approved monitored sensors for entrapment and pinch points.
Steps to connect and configure monitored entrapment protection sensors.
Procedure for manually operating the gate operator in case of power failure.
Guidelines for placing control buttons for safe and accessible operation.
Requirements for installing warning placards for safety awareness.
Diagrams and dimensions for gate operator placement in pull-to-open configurations.
Diagrams and dimensions for gate operator placement in push-to-open configurations.
Step-by-step guide for securely attaching the gate operator to the gate post.
Procedure for setting the open and close limit positions for the gate.
Instructions for connecting the gate operator to a high voltage power source.
Alternative power connection using 24VAC, recommended with Modular Power Box.
Guide for powering the operator using Viking's Solar Package.
Connecting the motor cable for a single gate operator setup.
Connecting motor cables for dual gate operator setups.
Connects sensors for entrapment protection in both directions.
Connects sensors for entrapment protection in the closing direction only.
Adjusting speed, obstruction detection, overlap delay, and hold open timer.
Enables automatic gate opening during power failure.
Opens gate automatically when battery backup voltage is critically low.
Initiates audio/visual warning before gate motion.
Synchronizes operation with Barrier Arm Operators.
Configures force sensitivity for obstruction detection.
Activates the integrated heater for low-temperature operation.
Wiring instructions for external access control devices.
Explanation of how relays provide input to the control board.
Instructions for wiring and programming the radio receiver.
Wiring the FA-XP30-10K photocell for UL325 requirements.
Connecting plug-in loop detectors to the control board via a loop rack.
Best practices for installing vehicular loop detector sensors.
Connecting magnetic locks and lock solenoids to the control board.
Synchronizing operation with Barrier Arm Operators.
Explains control board LEDs and their meanings for troubleshooting.
Details LCD display messages and their troubleshooting references.
Provides step-by-step solutions for common troubleshooting issues.
Enables secure communication between two gate operators via Konnect technology.
Provides off-site access for diagnostics and firmware updates via cellular service.
Adds protection to high voltage power supply against surges.
Components for powering the operator with solar energy.
General| Model | X-390 |
|---|---|
| Category | Gate Opener |
| Max Gate Length | 20 ft |
| Operating Temperature | -4°F to 158°F |
| Motor Type | DC Motor |
| Battery | 12V DC Backup |
| Control Options | Keypad, Remote |
| Safety Features | Obstruction sensing |
To Next Page