Need help?Do you have a question about the Viking Access Systems L-3 and is the answer not in the manual?
General| Brand | Viking Access Systems |
|---|---|
| Model | L-3 |
| Category | Gate Opener |
| Language | English |
Visual representation of the gate operator's physical dimensions.
Indicates the operational weight of the gate operator unit.
Essential safety guidelines to prevent injury or death during gate operation.
Critical instructions for safe and compliant gate operator installation.
Steps for regular cleaning, inspection, and upkeep of the gate operator.
Fundamental safety precautions for product installation, usage, and maintenance.
Defines gate operator classes based on UL325 standards for different environments.
Definitions of key terms related to gate operators and classifications.
Guide for installing non-contact photo beams for entrapment protection.
Instructions for manually operating the gate during power failure.
Installation details for the reset switch for the audible alarm.
Guidelines for placing warning signs for user awareness.
Details on gate length, weight, power, and operating temperature.
Recommendations for safe and accessible placement of control buttons.
Diagram illustrating the front view of gate operator installation.
Diagram illustrating the rear view of gate operator installation.
Guidelines for concrete pad depth, dimensions, and conduit pathways.
Ensuring proper alignment of gate and operator before anchoring.
Attaching the operator securely to the concrete pad using anchors.
Guidance on installing chain brackets for a straight and level chain path.
Connecting the operator to AC power for operation and battery charging.
Recommendations for proper grounding to prevent electrical damage.
Connecting the wire harness for gate opening direction.
Diagram for reconnecting limit switch wires if they become disconnected.
Setting the fine-tune limit pot to zero on the control board.
Adjusting the 'Open' cam for the desired open gate position.
Adjusting the cam for the desired closed gate position.
Activating limit switches to begin the set-up process.
Performing gate cycles to calibrate limit switches.
Using the fine-tune limit pot for minor adjustments to the closed position.
Using the trim pot to precisely set the final stop of the gate travel.
Wiring two gate operators for synchronized operation.
Diagrams showing placement of loops for vehicle detection.
Recommended dimensions and placement for loop detectors.
Table guiding wire turns based on loop perimeter.
Wiring diagram for the loop rack and its connection to the control board.
Connecting safety devices like photo beams and edge sensors.
Wiring for devices that trigger gate opening, stopping, or closing.
Alternative photo beam installation for reopen functionality.
How to connect and operate the radio receiver for gate control.
Wiring and placement of the guard station for gate operation control.
Enables gate opening during power failure and maintains open state.
Detects obstructions and reverses gate movement, with adjustable sensitivity.
Allows manual gate movement during power failure with adjustable force levels.
Sets a predetermined time for the gate to remain open before closing automatically.
Instructions for installing VikingBlue modules for master/slave wireless communication.
Connecting the solar panel controller to power the gate operator.
Step-by-step guide for connecting solar panels, batteries, and transformer.
Details on the material and included hardware for the pipe stand.
Guidelines for installing the pipe stand assembly parallel and square to the gate.
Details on the material and included hardware for the pedestal stand.
Guidelines for installing the pedestal stand assembly parallel and square to the gate.
Guide to installing and using Viking Blue software with computer or PDA.
Checks for motor indicator ON/OFF and fuse issues when the gate doesn't run.
Addressing issues with obstruction sensor activation and audio alarms.
Troubleshooting problems with the automatic closing feature.
Resolving issues where the gate opens or closes in the wrong direction.
Diagnosing issues with the gate opening, closing, or stopping unexpectedly.
Troubleshooting low or zero battery voltage readings.
Overview of UL compliance and key operational features of the gate operator.
To Next Page
