Need help?Do you have a question about the Viking Access Systems I-770 and is the answer not in the manual?
Identifies and describes the various components and connectors on the control board.
Lists and illustrates the physical parts of the gate operator mechanism.
Lists and illustrates the components of the gate operator's electronic control unit.
Key safety guidelines for gate operator use and general precautions.
Essential guidelines for installing the gate operator safely and correctly.
Mandatory requirements for entrapment protection sensors for UL 325 compliance.
Procedures for routine inspection and upkeep of the gate operator system.
Broad safety rules to follow during installation, use, and maintenance of the operator.
Defines classes of gate operators based on application and location as per UL 325.
Step-by-step guide for installing monitored entrapment protection sensors.
Instructions on how to manually operate the gate in case of power failure or malfunction.
How to install a reset switch for the audible alarm triggered by entrapment events.
Guidelines for properly placing warning signs for the gate operator.
Technical details and performance ratings for the gate operator.
Site preparation and placement considerations for gate operator installation.
Step-by-step instructions for physically mounting and connecting the gate operator.
Detailed instructions for connecting a high voltage power source to the gate operator.
Guidelines for powering the gate operator using a low voltage supply.
Instructions on how to connect and configure the gate operator for solar power.
Wiring instructions for the primary motor in a single-gate system.
Wiring instructions for the secondary motor in a dual-gate system.
Explanation of the status LEDs indicating the gate's open and close limit positions.
Configuration of core operational parameters like speed, overlap, and obstruction detection.
Details on setting up and understanding the obstruction detection sensor.
Instructions for activating and using the integrated heater for cold weather.
Connecting devices to the UL input for entrapment protection.
Connecting devices to the Re-Open input for closing direction entrapment protection.
Connecting and configuring a radio receiver for gate control.
Wiring for anti-tailgate features, open commands, and guard station controls.
Connecting a pre-wired loop rack for loop detectors.
Best practices for installing induction loops for vehicle detection.
Connecting magnetic locks and lock solenoids to the control board.
Configuring synchronized operation between the gate operator and barrier arms.
Explains the function of control board LEDs for troubleshooting.
Interpreting messages and status indicators shown on the LCD display.
A reference table linking troubleshooting codes to solutions and relevant pages.
Detailed guide on connecting various access control devices to the terminals.
Explains the function and common use of relays in access control devices.
Lists Viking terminal functions and their corresponding input behavior.
Illustrates an example connection for photobeam safety sensors.
Instructions for activating and configuring the Solar Mode feature.
Details on various expansion products like Konnect, Monitor, Surge Pro, and Solar Kit.
General| Brand | Viking Access Systems |
|---|---|
| Model | I-770 |
| Category | Gate Opener |
| Language | English |
To Next Page