Need help?Do you have a question about the Viking Access Systems Q-7 and is the answer not in the manual?
General| Model | Q-7 |
|---|---|
| Category | Gate Opener |
| Motor Type | DC |
| Battery Backup | Yes |
| Remote Control | Yes |
| Safety Features | Obstruction Detection |
| Warranty | 5 years |
Covers general safety, installation safety, UL325 classification, entrapment protection requirements, installation, and alarm/placard installation.
Details operator specifications, power requirements, and concrete pad installation procedures.
Explains the importance of positive stops and proper operator placement for gate travel.
Guidelines for preparing and installing the concrete pad for the operator.
Steps for connecting the high voltage power supply to the operator.
Information and considerations for setting up the gate operator with a solar power supply.
Step-by-step instructions for setting the gate's open and close limit positions.
Instructions for establishing master/slave communication using a two-wire system.
Details on setting up wireless master/slave communication with optional kits.
Configuration of basic operator settings like speed, obstruction detection, overlap, and timer.
Configuration of auto open, last open, and pre-warning power failure options.
Setup of obstruction sensor, integrated heater, and lock mode features.
Connecting a photo beam for vehicular safety to re-open the gate.
Connecting a radio receiver to control the gate, with options for operation modes.
Wiring for anti-tailgate, command inputs, and connecting loop detectors using the Viking Loop Rack.
Wiring and power considerations for magnetic locks and lock solenoids.
Procedure for synchronizing the gate operator with a Viking Barrier Arm model B-12.
Explains the meaning and status of control board LEDs for troubleshooting.
Interpreting messages and codes displayed on the control board's LCD for diagnostics.
Step-by-step solutions to common issues identified by error codes or LED status.
Details on connecting various access control devices to the gate operator.
Explanation of how relays function and are wired for external devices.
Wiring diagrams for common radio receiver models to the gate operator.
Minimum system requirements and installation information for solar power applications.
To Next Page
