VIKING TECHNICAL SUPPORT 1.800.908.0884
2
TABLE OF CONTENTS:
CONTROL BOARD REFERENCES 3
PARTS DIAGRAM/PARTS LIST - OPERATOR 4
PARTS DIAGRAM/PARTS LIST - CONTROLLER 5
IMPORTANT SAFETY INFORMATION 6-12
Important Safety Instructions 6
Important Installation Instructions 7
Maintenance 8
General Safety Precautions 8-9
Operator Classification 9
Entrapment Protection Requirements 10
Entrapment Protection Installation 11
Manual Release 11
Audible Alarm Reset Installation 12
Warning Placard Installation 12
IMPORTANT INSTALLATION INFORMATION 13
Specifications 13
GATE OPERATOR INSTALLATION 14-18
Plans of Installation 14-15
Installing the Gate Operator 16-17
Limits Setup 18
ECU BOX INSTALLATION 19
ELECTRICAL INSTALLATION 20-23
High Voltage Supply Option 20
Low Voltage Supply Option 21
Solar Supply Option 21
Motor Cable 22-23
LIMITS INDICATIONS 24
CONTROL BOARD SETUP 25-28
Initial Settings 25-26
Obstruction Detection Sensor (ODS) 27
Heater 28
ACCESSORY CONNECTIONS 29-35
UL, Re-Open (Monitored Input Terminals) 29
Radio Receiver (Typical) 30
Anti-Tail Gate, Open Commands, Guard Station 31
Viking Loop Rack 32
Guidelines for Loop Installations 33
Magnetic Lock, Lock Solenoid 34
Barrier Arm Synchronization Option 35
TROUBLESHOOTING 36-41
LED References 36-37
LCD Display References 38-40
Solutions 41
APPENDIX A, B, C 42-45
VIKING EXPANSION PRODUCTS 48
To Next Page
Loading...
