VIKING TECHNICAL SUPPORT 1.800.908.0884 X-390 • Rev A1 • October 2020
1
TABLE OF CONTENTS:
IMPORTANT SAFETY INFORMATION 2-9
Important Safety Instructions 2
Important Installation Instructions 2-3
Maintenance 4
General Safety Precautions 4-5
UL325 Gate Operator Classifications 5
Monitored Entrapment Protection Requirements 6
Monitored Entrapment Protection Installation 7
Manual Release 7
Audible Alarm Reset Installation 8
Warning Placard Installation 9
SPECIFICATIONS 10
CONTROL BOARD REFERENCES 11
GATE OPERATOR INSTALLATION 12-15
Plans of Installation 12-13
Installing the Gate Operator 14
Limits Setup 15
ECU BOX INSTALLATION 17
ELECTRICAL INSTALLATION 18-21
High Voltage Supply Option 18
Low Voltage Supply Option 19
Solar Supply Option 19
Motor Cable 20-21
Monitored UL Sensor Connections 22
LIMITS INDICATIONS 23
CONTROL BOARD SETUP 24-27
Initial Settings 24-25
Obstruction Detection Sensor (ODS) 26
Heater 27
ACCESSORY CONNECTIONS 28-35
Access Control Connections 28-29
Radio Receiver 30
Photocell 31
Viking Loop Rack 32
Guidelines for Loop Installations 33
Magnetic Lock, Lock Solenoid 34
Barrier Arm Synchronization Option 35
TROUBLESHOOTING 36-41
LED References 36-37
LCD Display References 38-40
Solutions 41
APPENDIX A 42
PARTS DIAGRAM/PARTS LIST - OPERATOR 44
PARTS DIAGRAM/PARTS LIST - CONTROLLER 45
LIMITED WARRANTY 46-47
VIKING ACCESSORIES 48
To Next Page
Loading...
