To Next PageTo Next PageWhat causes ice build-up on the ejector blades in my Viking Refrigerator?
Ice build-up on the ejector blades can be due to hollow cubes (see solutions for hollow cubes), the ice maker freezing up (remove the ice maker and allow it to thaw), or incorrect fill level (adjust the water fill level).
Why is my Viking Refrigerator too cold?
If your Viking Refrigerator is too cold, adjust the control setting to the medium position. Also, verify the proper operation of the control board and ensure proper airflow.
What to do if my Viking Refrigerator is running but has no lights?
If your Viking Refrigerator is running but the lights are not working, first, check if it's in Sabbath Mode and take it out of this mode. If not, there may be an open circuit, requiring replacement of the control board. Also, try replacing the light bulb.
What causes hollow cubes in a Viking RDDFF236?
Hollow ice cubes can be caused by several factors: low water in the mold due to a thermostat short cycle (replace the ice maker thermostat), the unit or ice maker not being level (level the ice maker or unit), obstructions in the fill tube (remove obstructions), or low water pressure (replace the filter).
Why are the ice cubes jammed in my Viking Refrigerator (small or oversized)?
If the ice cubes are jammed (small or oversized), level the ice maker or the unit. Also, adjust the water fill level to ensure it is proper.
What to do if there is frost on the evaporator of my Viking Refrigerator?
If there is frost on the evaporator, check the defrost thermostat indicator. Also, check the evaporator fan's connection for shorts or open conditions. Verify the operation of the defrost heater and ohm heater. Finally, check the door seal to ensure it closes properly; replace if needed.
Why is there no water to my Viking RDDFF236 ice maker?
If there is no water going to the ice maker, first, make sure the water supply is turned on. Then, check the supply line for any blockages. Also, inspect the water valve for obstructions and confirm that the valve is working.
Why is there no water to my Viking Refrigerator?
If there's no water supply to your Viking Refrigerator, first, ensure the water supply is turned on. Next, inspect the supply line for any obstructions. Also, check the water valve for obstructions and verify its operation.
What to do if my Viking Refrigerator unit will not operate?
If your Viking Refrigerator won't operate, check the power supply to verify the voltage. Also, reset the circuit breaker and ensure the power switch is in the “ON” position.
Why is my Viking RDDFF236 Refrigerator freezer too warm?
If your Viking freezer is too warm, consider the following: Adjust the control setting to medium. Check the door seal and replace if needed. Clean the condenser coil if it's dirty. Verify the condenser fan operation and ensure it's free of obstructions. Check the control board and defrost heater operation. Lastly, verify the thermistor operation.
General| Brand | Viking |
|---|---|
| Model | RDDFF236 |
| Category | Refrigerator |
| Type | French Door |
| Refrigerator Capacity | 15.1 cu. ft. |
| Finish | Stainless Steel |
| Color | Stainless Steel |
| Ice Maker | Yes |
| Water Dispenser | Yes |
| Energy Star Certified | Yes |
| Width | 35.75 inches |
| Depth | 29.19 inches |
Provides important safety messages and alerts for hazards.
Lists potential hazards like tip over, electrical shock, and burn hazards.
Explains how to use the appliance's control panel and its functions.
Details how to adjust refrigerator and freezer temperatures using controls.
Details test points and readings for various components connected to the control board.
Provides common problems, probable causes, and corrections for appliance issues.
