What to do if my Viking VGRC485 door locks, fan runs, but no heat?
If the door lock motor is engaged on your Viking Ranges, the cooling fan motor runs, but there is no heat, it could be due to: * The door lock module/timer relay not closing. * A problem with SW3 on the door lock assembly. To fix this, you may need to replace the PC board or SW3.
Details the replacement of the orifice spud for infrared broilers.
Adjusting the air shutter to achieve a blue flame without yellow tipping.
Adjusting the orifice hood to control flame size for proper gas flow.
Adjusting the orifice hood to achieve a sharp blue inner cone flame.
Adjusting the air shutter for a blue flame without yellow tipping or lifting.
Steps for adjusting the grill burner air shutter and flame.
Steps for adjusting the griddle burner air shutter and flame.
Instructions for calibrating oven temperature using the adjusting screw.
Methods for testing igniter continuity and measuring current draw.
Describes gas valve function and procedures for testing its components.
Step-by-step instructions for safely removing the oven door.
Instructions for correctly reinstalling the oven door.
Procedure for removing the oven door handle and logo.
Instructions for safely removing the oven door hinges.
Steps for removing the control panel, including knobs and screws.
Procedure for removing the landing ledge after other components are detached.
Instructions for removing the top burner assemblies and ignitor wires.
Procedure for removing the ignitor from the top burner support.
Details on removing the spark module and disconnecting wiring.
Procedures for removing oven ignitors and bake/broil gas valves.
Instructions for replacing top burner valves and the pressure regulator.
To Next Page
General
