vimec V 64 - Platform Assembly with Driven Front Access

24
a
a
a
c
d
b
a
7511131
The guide shoe of the chain microswitch must always
act on the inner chain as indicated in (Fig. 18bis/i).
N.B.: Do not over-stretch the chain.
- If necessary, use the handwheel for manual operation
to adjust the chain in order to simplify tting of the
chain stretcher - Fig. 19/a.
- Remove the supporting feet and handles from the
lift body.
7) ASSEMBLING THE PLATFORM WITH DRIVEN
FRONT ACCESS (B.I. - B.R.)
On customer request it is possible to have a footboard
with overturning front side (Fig. 20/a).
Such a footboard permits, on the lower oor only, to
access/go down perpendicularly to the machine.
7.1) Assembling the platform
a) Remove the top plate from the platform by undoing
the relative screws.
b) Make sure that the two platform supports, xed by a
wedge and a plastic clamp, are in the assembly position
(Fig. 21/a/b).
FIG.20
FIG.23
FIG.21
FIG.22
FIG.19
7512131