EasyManua.ls Logo

VIMUKUN CM7033-UL - Blended Coffee Brewing

VIMUKUN CM7033-UL
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
*Keurig® and K-Cup® are registered trademarks of Keurig Green Mountain, Inc.
**Nespresso® is a registered trademark of Societe des Produits Nestle S.A. and Nestlé Nespresso S.A.
Use of the Nespresso® trademark does not imply any affiliation with or endorsement by Societe des Produits Nestle S.A.
or Nestlé Nespresso S.A.
BLENDED COFFEE BREWING
Squeeze in an extra boost of caffeine by adding a shot of espresso to your coffee. When
activated, Boost will illuminate on the Control Panel.
Fill the Water Reservoir. Before brewing, ensure there’s enough water in the Water Reservoir.
When the Water Reservoir is less than 12oz, there will be a water shortage alarm to remind,
and other buttons do not work except for the Power button.
Lift the handle and open the top lid (see Fig.1),insert a *K-Cup® pod (see Fig.2) and a
**Nespresso® pod (see Fig.6) of the Pod Brew Area, then press the handle down to close the
top lid (See Fig.7). Inside the Pod Brew Area, there are two inlets of different shapes,
sideby-side. The left inlet fits a *K-Cup® pod, while the right inlet fits a **Nespresso® pod. To
brew a cup of coffee, insert a *K-Cup® into the left inlet making sure to secure it firmly in
place.
After the machine has warmed up, all icon and coffee brew size buttons will illuminate white.
Select the *K-Cup® brew size you want first then select the **Nespresso®Pod brew size. The
corresponding will light up, and then press the Brew button to brew the coffee in order.
Firstly, the *K-Cup® capsule brewing system is activated and the desired amount of coffee is
brewed. And then the **Nespresso® capsule brewing system is activated and the desired
amount of coffee is brewed. The corresponding indicator of the selected cup size will flash in
blue during brewing process.
1.
2.
3.
4.
WARNING: Be careful not to overfill the Water Reservoir.
NOTE: When the water in the reservoir is less than 12oz, the blue water droplet will
illuminate and flash on the Control Panel. If this happens in mid-brew cycle, do not operate on
the button and add water immediately.
NOTES: Only need to press any cup size button if need to exit from the "Boost" mode, at that
time, the indicators of selected cup size and coffee type illuminate in blue, while other
indicators illuminate in white and the indicator of "Water drop shape" turns off.
NOTES: Which cup amount is selected, the corresponding button light turns blue, the same
capsule type, only the last selected button light blue.