What to do if my VINCENT Amplifier has no function after switching on?
If your VINCENT Amplifier has no function after being switched on, ensure the power cable is securely connected to a working wall outlet. Also, verify the power cable isn't defective by testing with a replacement. Finally, check and replace the fuse if it's blown.
Why remote commands have no effect on my VINCENT Amplifier?
If your VINCENT Amplifier's remote commands have no effect, start by checking and replacing the batteries in the remote. Ensure there's a clear line of sight between the remote and the amplifier, and that you're within the maximum operational distance, facing the front panel. Also, ensure that the device is switched on.
What to do if VINCENT Amplifier display is functional but there is no playback?
If your VINCENT Amplifier display is functional but there's no playback, first, carefully increase the volume. Then, make sure the correct input channel is selected. Check that the source device is properly connected to the pre-amplifier and is actively playing. Also, verify that the main amplifier is correctly connected, functioning, and that the speaker cables and their connections are in good order.
How to fix one channel play back only on VINCENT Amplifier?
If your VINCENT Amplifier is only playing back on one channel, check the speaker cables and their connections on both ends, ensuring they are properly connected and not defective. Also, inspect the signal cables between the pre-amplifier and main amplifier, as well as those between the source and pre-amplifier, for secure connections and any defects. Finally, check and correct the balance setting.
Product servicing, modifications, and power source requirements.
Proper handling of power cord and fuse replacement.
Advice on connecting devices, quality, and safety precautions.
Connecting pre-amplifier to main amplifier via RCA.
Connecting pre-amplifier to main amplifier via XLR.
Connecting various audio sources via RCA/XLR and setup advice.
Connecting a recording device to the REC Output.
Switching on/off, setting volume, and selecting input channels.
Troubleshooting no function, playback, channel, remote, and noise problems.
General| Frequency Response | 10 Hz - 20 kHz +/- 0.5 dB |
|---|---|
| Nominal Output Power at 8 Ohm | 2x 100 W |
| Input Sensitivity | 280mV |
| Input Impedance | 47 kOhm |
| Inputs | 4 x RCA |
| Weight | 20 kg |
| Total Harmonic Distortion | <0.1% |
| Outputs | Speaker terminals |
| Mains Supply | 230 V/50 Hz |
| Power Output | 2 x 100W (8 Ohm) |
To Next Page
