To Next PageTo Next Page
Need help?Do you have a question about the VINCENT SV-237 and is the answer not in the manual?
General| Total Harmonic Distortion | < 0.1% (1 kHz, 1W) |
|---|---|
| Signal-to-Noise Ratio | > 90 dB |
| Dimensions | 430 x 150 x 435 mm |
| Input Impedance | 47 kOhms |
| Type | Integrated Amplifier |
| Frequency Response | 20 Hz - 20 kHz |
| Inputs | RCA |
| Outputs | 1 x Pre-out |
| Tube Complement | 1 x 12AX7, 2 x 6N1P |
All maintenance work must be left to qualified professionals. Avoid product alteration.
Connect and disconnect the power cable correctly. Ensure it's not damaged or pinched.
Switch off the device before connecting/disconnecting components or power. Wait one minute.
Protect the appliance from liquids, moisture, and extreme temperatures.
Ensure adequate ventilation by maintaining a 5cm gap around the unit. Do not cover vents.
Use caution with volume settings to prevent hearing damage. Set low before changing inputs.
Unplug before cleaning. Use a soft, damp cloth. Avoid abrasive or solvent-based cleaners.
Note instructions for battery usage and disposal for the remote control.
Adjusts the high frequencies of the sound. Middle position leaves treble unchanged.
Adjusts the low frequencies of the sound. Middle position leaves bass unchanged.
Shows the illuminated tube element of the amplifier.
Selects one of the six available audio input sources for playback.
Adjusts the main volume level for speakers and preamplifier output.
Troubleshooting steps for power issues, including cable checks and fuse.
Addresses issues like loose connections, dirty connectors, or incorrect tone settings.
Diagnosing issues when the unit is on but no sound is produced.
Troubleshooting why the remote control is not performing its functions.
Troubleshooting one-sided sound issues, checking source and speaker connections.
Addresses audible humming noise when no audio source is playing.
