Need help?Do you have a question about the VINCENT SP-331 and is the answer not in the manual?
General| Amplifier class | - |
|---|---|
| Frequency range | 10 - 50000 Hz |
| Input sensitivity | 1200 mV |
| Audio output channels | - channels |
| Peak power per channel | - W |
| Signal-to-Noise Ratio (SNR) | 90 dB |
| Total Harmonic Distortion (THD) | 0.1 % |
| RMS power output per channel (4 Ohm) | 600 W |
| RMS power output per channel (8 Ohm) | 300 W |
| Purpose | Home |
| On/off switch | Yes |
| Product color | Black |
| Connectivity technology | Wired |
| Speakers connectivity type | Clamp terminals |
| Built-in display | No |
Weight and Dimensions| Depth | 450 mm |
|---|---|
| Width | 430 mm |
| Height | 160 mm |
| Weight | 19000 g |
Covers electric shock hazards, maintenance restrictions, and general precautions to prevent user harm.
Details on power connection, switching, environmental factors like heat/moisture, and volume control.
Provides proper methods for cleaning the appliance and general advice on maintenance procedures.
Guidance on system placement, electronic waste disposal, and meeting CE mark requirements.
Details on product declarations, copyright, development, and the importance of original packaging.
Provides meanings for symbols indicating electrical hazards and important operational information.
Description of the main power switch for turning the device on and off.
Explanation of the LED that indicates when the appliance is switched on.
Details on connecting loudspeakers using threaded terminals and banana plugs.
Information on connecting preamplified signals from a preamplifier.
Location and purpose of the fuse holder for safety.
Describes the connection for the mains power cable.
Instruction to remove protective caps from rear unit connections before installation.
Guidance on connecting RCA cables, including color coding and avoiding damage.
Advice on connecting speaker cables, including polarity and impedance.
General advice for tight plug connections to prevent interference and failures.
Guidance on connecting one or two pairs of loudspeakers using 2-core cables.
Instructions for connecting loudspeakers with Bi-Wiring terminals, including metal brackets.
Further explanation of bi-wiring, frequency range filtering, and polarity.
How to connect loudspeaker cables with 4 mm banana plugs.
Instructions for using spade lug connectors with speaker cables.
How to connect bare speaker wires to terminals without connectors.
Describes using the POWER button and the initial warm-up phase of the amplifier.
Explains the need for a warm-up period for audio components to reach optimal performance.
Discusses potential causes of humming noise and troubleshooting steps.
Troubleshooting steps for when the unit fails to power on.
Steps to resolve issues when the unit is on but no audio is produced.
Diagnosing and fixing problems with audio output on only one channel.
Identifies loose connections or defective cables as causes for degraded audio quality.
Addresses persistent humming noise when no audio source is active.
Defines input sensitivity as the minimum input voltage for maximum output power.
Explains decibels (dB) as a unit for measuring signal voltage and volume.
Describes RCA connectors and sockets, their origin, and usage for audio/video signals.
To Next Page
