22
Vincent
3. SPEAKERS: Loudspeaker terminals
At these output sockets with threaded terminals
one or two pairs of loudspeakers can be connec-
ted. Speaker cable with 4 mm banana plugs can
be used. Please take note of the information given
in the section “Installation”, if two pairs of loud-
speakers will be connected to the amplifier.
4. INPUT: Input for preamplified
mono audio signal
This input must be connected with the output connec-
tors of the preamplifier for the desired channels. For
example, with “PRE OUT R”/ “PRE OUT L”, if the SP-
331 is to be used for the loudspeakers of a stereo
system. Do not connect any line level sources!
5. FUSE: Fuse holder
This small plastic housing holds the fuse. Refer to
the security precautions.
6. AC 220-240V: Power Connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitab-
le wall outlet.
REAR VIEW
4 5 6
3
To Next Page
Loading...
